I think the more fishing we do, the more we learn the specifics matter less, and the general idea often gets the job done. That’s the deal with the classic Muddler minnow, especially for steelhead. It’s simple, impressionistic, and can be fished and tied in a variety of ways to best suit your local waters. Here’s how to tie a varient I use on my local Steelhead waters, fished up top or with a tip on the swing.
Have fun!
Brandon
Step 1: Gather materials
-Dark Deer Hair, Diamond Braid, thread wax, maribou (any color, this one uses burnt orange) Steelhead hook. Note: If you plan to fish this on the surface, consider a lighter guage hook. Use heavy thread for this tie, I like Veevus 140.
Step 2: Snip a small clump of hair for the tail and tie in at the point of the hook below, allow it to extend past the bend of the hook a bit. Tie in several inches of Diamond braid. You will palmer this towards the eye to make the body next…
Step 3: Palmer the diamond braid up the body to the return of the eye and tie off.
Step 4: Tie in a small clump of Maribou even with the tail, then tie in a small clump of deer hair over the top of the bou’ for an over wing. Less is more here …
Step 5: Leave enough room here for a generous amount of spun deer hair for the collar and head.
Grab a liberal hank of deer hair…
Step 6: Spin the deer hair. Wrap lightly around the shank and hair once, softly, then continue a second wrap, slightly more pressure. Third wrap, harder still allowing the hair to spin around the shank of the hook and the thread to tighten up. Continue tension for a 4th wrap through the hair until the thread is clear of the hair.
Step 7: Trim hair. This is where you decide how you want the head to look. Leave a lot of hair and this thing will push a ton of water, but a tighter trimmed head casts easier. Either way, trim up the butts with your scissors and admire the result. Then, tie one on and let er’ rip!
Happy tying,
Brandon
